PAL3030，PAL 3030，PAL3040，PAL 3040，PAL3050，PAL 3050,sheet piles

PAL3030 and PAL3040 sheet piles may not modify a shoreline or construct a dock, bulkhead, or shoreline access unless the person first obtains a site plan and building permit, as applicable, and pays the applicable permit fee set by ordinance. Construction of retaining walls, except those less than 3 feet in height and not supporting surcharge, requires a permit and is regulated by the 2013 California Building Code (CBC) as amended and adopted by the County of San Diego. A permit is required before constructing or expanding a retaining wall, pier or boat dock. The following PAL3040 information is required before a permit will be issued. (B) The building official or the director of the Parks and Recreation Department shall require the applicant to place an PAL 3050 identification or registration tag on a dock. 1. A plot plan of the property, which shows property lines and where the structure will be placed in relation to your property line and house. This PAL3030 form outlines the County’s minimum requirements. The companion form PDS #084 provides information on retaining walls with level backfill. For site retaining walls proposed to be constructed in a public way or associated with Department of Public Works grading, County of San Diego Regional Standards shall be used. I. INSPECTIONS Please call for inspections at the following times: 1. When the footing excavations have been completed, the reinforcing steel has been securely tied into final position, and before the placement of concrete. A person may not remove a tag placed under this subsection.

PAL3050 or PAL 3030 steel sheet pile obtained under this section shall be prominently displayed at the construction site until the final inspection and approval by the building official. Include the distance, in feet, from the property lines to the PAL 3050 proposed structure • Retaining walls cannot encroach into the lake past the existing vegetation line. The director of the Planning and Development Review Department may not approve an application for a permit for the construction of more than two PAL 3040 residential docks or other similar structures on a single lot zoned MF-1 or more restrictive, unless: After grouting is completed and after rock or rubble wall drains are in place, but before backfill is placed. the lot was platted and recorded before August 26, 1976, and perpetual rights to use the water frontage of the lot were granted or conveyed to one or more owners of other lots in the subdivision before June 23, 1979; or No PAL 3030 building foundation, driveway, parking or other loading on the upper level is allowed within a distance equal to the height of the wall. the Parks and Recreation Board has approved a site plan that clusters the residential docks on one or more lots in the subdivision. A City of Bonham Representative PAL3050 will confirm the location of the vegetation line. If a permit is required under this section and is not obtained before construction begins, the required fee is increased by an amount established by ordinance. Payment of the additional fee does not relieve a person from complying with this Code. When the block has been laid and the reinforcing PAL3050 steel is in position, but before any grout has been placed. Steel is to be securely fastened in place to prevent movement during PAL 3040 grouting. All material to be used must be approved by the City of Bonham. • Piers and docks must have a minimum setback of 10’ from the property lines except for the Meadows subdivision, which has a setback of 30’ from the property line.

Sheet piling are not to exceed PAL 3040 or PAL 3050 high and blocks are not to be laid higher than the grout pour. 3.4. When all work has been completed. II. WALL HEIGHT Wall height is measured from the top of the footing to the top of the PAL3040 wall. Where an inspection is required by state law, neither a Certificate of Compliance nor a final inspection may be issued for shoreline access unless the applicant has submitted an inspection report, signed by a QEI-1 inspector registered with the PAL 3030 Texas Department of Licensing and Regulation, stating that all applicable state regulations have been met. Walls that are not specifically shown in this form must be designed by a California licensed architect, civil or structural engineer. PAL3030 walls with such loading must be designed by a California licensed architect, civil or structural engineer.